Configuration For The Leuze Standard Protocol - Leuze electronic 1910i Technical Description

5.1.2

Configuration for the Leuze standard protocol

Leuze standard protocol:
RS 232 with 9600 baud, 8 data bits, 1 stop bit, no parity, prefix STX and suffix CR/LF
Factory settings
Return the IT 1911i to the base station so that the settings can be accepted. Successful reading is confirmed
by an acoustic signal and the red LED on the base station going out briefly.
To configure the device, please scan the codes in the specified order.
Successful reading is confirmed by an acoustic signal and the red LED on the base station going out briefly.
RS 232 baud rate: 9600
Prefix STX
Suffix CR/LF
Alternatively, the following Aztec configuration code can also be used:
The individual pieces of bar code information are
again provided in succession in the Aztec
configuration code.
Return the IT 1911i to the base station so that the
settings can be accepted. This procedure is
concluded with an acoustic signal.
Leuze electronic IT1911i 13