It 1911I To Ma 200I; Commissioning - Leuze electronic 1910i Technical Description

5.2 IT 1911i to MA 200i

RS 232 transmission with 9600 baud, 8 data bits, 1 stop bit, no parity, suffix CR/LF.
Required parts:
1x 50122434
1x 50122431
1x 50114517
1x 50123862
1x 50113397
1x 50112893
or 50112892
or 50112891
5.2.1

Commissioning

• Open the MA 200i
• Guide KB JST-HS-300 with the PG cable gland through the threaded hole and insert
the 12-pin JST connector
• Connect the base station with the RS 232 cable
• Connect the RS 232 cable to the 9-pin D-sub connector
• Set the address using the address switch
• Insert the field bus connection cable
• Apply the voltage supply.
Please connect the base station acc. to the following figure.
Leuze electronic
IT 1911i ER-3
Base station IT 1911i
KB 232-1 IT 190x
Power supply unit
KB JST-HS-300
MA 204i Profibus gateway
MA 208i Ethernet gateway
MA 248i Profinet gateway
IT1911i 14