Operation; Winterization - Hayward ColorLogic WFBCUS1100 Owner's Manual

Plume Height Adjustment
After the system has been started, you can adjust the water flow to get the desired effect. The
following tables provide approximate values for water column height with combinations of GPM and
depth of the ColorLogic
Plume height at given water depths:
When the pool is to be prepared for winter or will be out of service for a long period of time, the
following steps should be followed to ensure that the bubbler unit will not be damaged:
If water WILL be below bubbler level: remove retaining ring, lens, nozzle nut, and nozzle.
Vacuum or soak up all residual pool water from niche. Install the plaster shield that was saved
from installation along with the included O-ring. If these parts were not saved from installation, a
replacement winterization kit is available (GLX-BKT-XX) for order. See page 13 for details.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Operation

Bubbler. NOTE: Water heights may vary.
®
3/4" Nozzle Orifice
4"
Depth
15gpm
11
20gpm
15
25gpm 24
30gpm 35
35gpm 45
40gpm
-- 37.5
1/2" Nozzle Orifice
4"
Depth
10gpm
31
15gpm
48
20gpm 75

Winterization

6" 8" 10"
8 5 4.5
10 7 6
16 11 9
21 17 12
30 20.5 15
27 20
6" 8" 10"
16 -- --
26 15.5 12
43 25 19
12"
3.5
5
8
10.5
13
15
12"
--
10
15
Plaster Shield Installed with o-ring
for winterization if water will be
below Bubbler level.
12