LIMITED WARRANTY (effective 04/01/09) Hayward/Goldline warrants its Pro Logic IMPORTANT SAFETY INSTRUCTIONS and E-Command pool automation products as well as its Aqua Rite, Aqua Rite Pro, Aqua Plus and SwimPure chlorination products to be free of defects in materials and workmanship, under normal use and service, for a period of three (3) years.
Before You Begin Compatibility The AQL-CHEM-3-120 (120VAC) and AQL-CHEM-3-240 (240VAC) are compatible with all Hayward Aqua Rite Pro and Pro Logic pool controls using an AQL-CHEM Sense & Dispense system. The AQL-CHEM-3 is not compatible with Aqua Rite or Aqua Logic controls.
Advance through the Wizard until pH Reduction Control is displayed. Use "+" or • Check the Aqua Rite Pro or Pro Logic’s display each day before entering the "-" to set pH Reduction Control to "Forced On". water. If there is any Check System alarm, follow the troubleshooting guide in this Continue through the Wizard and exit.
Purge air out of the system by using the 15 minute force feed until the flow indicator shows that the acid solution is flowing. To do this, use the following procedure: Aqua Rite Pro Press the "Settings" button. Press ">" repeatedly until "Chemistry Config. Wizard" is displayed.
Page 6
Connect the AQL-CHEM-3 to the Aqua Rite Pro or Pro Logic control Plug the Stenner pump's linecord into the pH Dispense pigtail of the Aqua Rite Pro or Pro Logic. This pigtail is provided with the AQL-CHEM. If the pigtail isn't already installed, refer to the AQL-CHEM product manual for installation instructions.