Controls: Open; Feedback Signals Setting Via Output Contacts - AUMA SA 07.2 Operation Instructions Manual

SA 07.2 SA 16.2/SAR 07.2
AMB 01.1/AMB02.1
10.5.

Controls: open

10.6.

Feedback signals setting via output contacts

Setting
Information
SAR 16.2
Cable damage due to twisting or pinching!
Risk of functional failures.
Carefully mount local controls.
5. Fasten screws evenly crosswise.
Hazardous voltage!
Risk of electric shock.
Disconnect device from the mains before opening.
Electrostatic discharge ESD!
Risk of damage to electronic components.
Earth both operators and devices.
Loosen screws [2] and remove cover [1].
— (Option) —
Only valid for versions (B02 and B04) with output contacts K6, K7, K8 on relay board.
Feedback signals can be set via two jumpers on the relay board. Refer to the
<Feedback signals setting> table for the set functions
The jumpers for feedback signal setting are preset in the factory as specified in the
order. The wiring diagram pertaining to the order has been coded accordingly and
the connections for the signals (terminals XK) have been entered. In case of sub-
sequent change of the setting (rewiring of the jumpers), the wiring diagram provided
will no longer correspond to the changed settings. For this reason, setting changes
may exclusively be performed by the AUMA service.
Commissioning controls settings
43