Sony STR-ZA5000ES User Manual page 64

[95] Adjusting Settings Speaker Setup
4. Selecting the front speakers
You can select the front speakers you want to operate.
Be sure to use the buttons on the receiver to perform this operation.
Press SPEAKERS on the receiver repeatedly to select the front speaker system you
1
want to operate.
The indicators on the display panel shows which set of terminals are selected.
SP A:
Speakers connected to the SPEAKERS FRONT A terminals.
SP B (*):
Speakers connected to the SPEAKERS SURROUND BACK (FRONT B/BI-AMP/ZONE 2)
terminals.
SP AB (*):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK (FRONT B/BI-AMP/ZONE 2) terminals (parallel connection).
(None):
[SPEAKERS OFF] appears on the display panel. No audio signals are output from any
speaker terminals, or the PRE OUT jacks.
To select [SP B] or [SP AB], set the assignment for the SPEAKERS SURROUND BACK (FRONT B/BI-
*
AMP/ZONE 2) terminals to [Front B] by using [SB Speaker Assign] in the [Speaker Setup] menu.
[96] Adjusting Settings Speaker Setup
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Auto Calibration].
2
Follow the instructions on the TV screen, then press
3
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
Select the item you want.
4
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
For details on the measurement results, see "6. Checking Auto Calibration results."
5 Save the measurement results.
Select [Save] in step 4.
Calibration Matching
When Auto Calibration is executed, this function works automatically, matching the distance and
level of the right and left speakers. You can set this function only after the D.C.A.C.
measurement process has been completed and the results of the D.C.A.C. measurement are
saved. The setting is valid until you change it.
Note
If an error code or warning message appears on the screen in step 3, see "List of messages after
Auto Calibration measurements."
Hint
to select [Start].