Sony STR-ZA5000ES Service Manual

SERVICE MANUAL
Ver. 1.0 2016.03
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus affected unit was found during
service, contact your Service Headquarters.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated
120 watts per channel minimum RMS power, with no more than 0.09%
total harmonic distortion from 250 milliwatts to rated output.
Amplifier section
POWER OUTPUT 1) 2)
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%): 120 W + 120 W
Reference Power Output
(8 ohms 1 kHz, THD 0.9%)
FRONT: 130 W + 130 W
CENTER: 130 W
SURROUND: 130 W + 130 W
SURROUND BACK: 130 W + 130 W
HEIGHT 1: 130 W + 130 W
1) Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
2)
Depending on the sound field settings and the source, there may be
no sound output.
Frequency response*
SA-CD/CD, TV, AUX, VIDEO 10 Hz – 100 kHz
± 3 dB
Inputs (Analog)
SA-CD/CD, TV, AUX, VIDEO Sensitivity: 150 mV
Impedance: 50 kohms
S/N*: 105 dB (A, 20 kHz LPF, 500 mV)
* When "Direct" is being used and an analog input is selected.
Inputs (Digital)
IN (BD/DVD) (Coaxial) Impedance: 75 ohms
S/N: 96 dB (A, 20 kHz LPF)
S/N: 96 dB (A, 20 kHz LPF) IN 1 (AUX), IN 2 (TV) (Optical)
Outputs
ZONE2, ZONE 3 (AUDIO OUT) Voltage: 2 V
Impedance: 1 kohm
FRONT L/R, CENTER, SURROUND L/R, Voltage: 2 V
SURROUND BACK L/R, HEIGHT 1 L/R, Impedance: 1 kohm
HEIGHT 2 L/R, SUBWOOFER
FM tuner section
Tuning range
87.5 MHz – 108.0 MHz
Antenna (aerial)
FM wire antenna (aerial)
Antenna (aerial) terminals
75 ohms, unbalanced
AM tuner section
Tuning scale Tuning range
10 kHz step 530 kHz – 1,710 kHz
9 kHz step 531 kHz – 1,710 kHz
Antenna (aerial)
Loop antenna (aerial)
9-896-281-01
Sony Video & Sound Products Inc.
2016C33-1
©
2016.03 Published by Sony Techno Create Corporation
STR-ZA5000ES
SPECIFICATIONS
Video section
Inputs/Outputs
Video: 1 Vp-p, 75 ohms
Inputs
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P : 0.7 Vp-p, 75 ohms
B
P : 0.7 Vp-p, 75 ohms
R
80 MHz HD Pass Through
HDMI Input/Output (HDMI Repeater block)
HDMI IN 1, 2, 3, 4, 5 and all HDMI OUT jacks support bandwidth up
to 18 Gbps, and HDMI IN 6 (GAME) jack supports bandwidth up to 9
Gbps.
All HDMI IN and HDMI OUT jacks support HDCP 2.2, ITU-R BT.2020
wide color spaces, and HDR (High Dynamic Range) contents pass-
through.
HDCP 2.2 is newly enhanced copyright protection technology that
is used to protect content such as 4K movies.
BT.2020 color space is new wider color standard that is defined for
ultra-high definition television systems.
HDR is an emerging video format that can display a wider range of
brightness levels.
Supported video formats
Format 2D
Frame Side-by-
packing Side (Half)
4096 × 2160p @ 59.94/60 Hz
4096 × 2160p @ 50 Hz *
4096 × 2160p @ 29.97/30 Hz **
4096 × 2160p @ 25 Hz **
4096 × 2160p @ 23.98/24 Hz **
3840 × 2160p @ 59.94/60 Hz *
3840 × 2160p @ 50 Hz *
3840 × 2160p @ 29.97/30 Hz **
3840 × 2160p @ 25 Hz **
3840 × 2160p @ 23.98/24 Hz **
1920 × 1080p @ 59.94/60 Hz
1920 × 1080p @ 50 Hz
1920 × 1080p @ 29.97/30 Hz
1920 × 1080p @ 25 Hz
1920 × 1080p @ 23.98/24 Hz
1920 × 1080i @ 59.94/60 Hz
Canadian Model
F r o m t a
1920 × 1080i @ 50 Hz
1280 × 720p @ 59.94/60 Hz
1280 × 720p @ 50 Hz
1280 × 720p @ 29.97/30 Hz
1280 × 720p @ 23.98/24 Hz
720 × 480p @ 59.94/60 Hz
720 × 576p @ 50 Hz
640 × 480p @ 59.94/60 Hz
* If you use YCbCr 4:4:4/YCbCr 4:2:2/RGB 4:4:4 or YCbCr 4:2:0 deep
color (10 bit or 12 bit) of these video formats, be sure to use HDMI IN 1,
2, 3, 4 and/or 5 jacks, and Premium High Speed HDMI Cables, which
can support bandwidth up to 18 Gbps.
** If you use deep color (10 bit or 12 bit) of these video formats, be sure
to use HDMI IN 1, 2, 3, 4 and/or 5 jacks, and Premium High Speed HDMI
Cables, which can support bandwidth up to 18 Gbps.
General
Power requirements
120 V AC, 60 Hz
Power consumption
500 W
Power consumption (during standby mode)
0.3 W (When "Control for HDMI," "Audio Return Channel," "Pass
3D
Through," "Network Standby," and "External Control" are set to "Off,"
Over-Under
and the power for zone 2/zone 3 is turned off.)
(Top-and-
Dimensions
Bottom)
430 mm × 174 mm × 410 mm (17 in × 6
height/depth) including projecting parts and controls
Mass (Approx.)
17.5 kg (38 lb 10 oz) including the front cover
17.1 kg (37 lb 12 oz) not including the front cover
Supplied accessories
Operating Instructions
Startup Guide (1)
Optimizer microphone (ECM-AC1) (1)
FM wire antenna (aerial) (1)
AM loop antenna (aerial) (1)
AC power cord (mains lead) (1)
Remote control (RM-AAU217) (1)
R03 (size-AAA) batteries (2)
Front cover (1)
Design and specifications are subject to change without notice.
MULTI CHANNEL AV RECEIVER
US Model
3D
Over-Under
2 D
Frame Side-by-
(Top-and-
packing Side (Half)
Bottom)
7 1
/ in × 16 / in) (width/
8 4