List Of Messages After Auto Calibration Measurements; Network Features Message List; The Receiver Is Turned Off Automatically - Sony STR-ZA5000ES User Manual

Multi channel av receiver
Hide thumbs Also See for STR-ZA5000ES:
Table of Contents

Advertisement

FAN STOPPED
Check that the ventilation holes on the top of the receiver are not blocked.
[169] Troubleshooting
Error messages

List of messages after Auto Calibration measurements

Code 31:
Front speakers are not selected properly. Select the front speakers using SPEAKERS and
perform the Auto Calibration again. For details on selecting the front speakers, see “4.
Selecting the front speakers.”
Code 32, Code 33:
Speakers were not detected or not connected properly.
None of the front speakers are connected or only one front speaker is connected.
Either the surround left or surround right speaker is not connected.
A surround back speaker is connected only to the SPEAKERS SURROUND BACK
(FRONT B/BI-AMP/ZONE 2) R terminal. If connecting only one surround back speaker,
connect it to the SPEAKERS SURROUND BACK (FRONT B/BI-AMP/ZONE 2) L
terminal.
Either the HEIGHT 1 left or HEIGHT 1 right speaker is not connected.
Either the HEIGHT 2 left or HEIGHT 2 right speaker is not connected.
The optimizer microphone is not connected. Make sure that the optimizer microphone is
connected properly and perform the Auto Calibration again.
If the optimizer microphone is connected properly but the error code still appears, the
optimizer microphone cable may be damaged.
Code 34:
Speakers are not placed in the proper position. Speakers or the optimizer microphone on
the right or left may be placed wrongly.
Code 35:
The measurement result is not match to the speaker pattern you set.
Warning 40:
The measurement process has been completed and a high noise level has been detected.
You may be able to achieve better results if you try the process again in a quiet
environment.
Warning 41, Warning 42:
The input from the optimizer microphone is too large.
The distance between the speaker and the optimizer microphone may be too small. Set
them further apart and perform the measurement again.
Warning 43:
The distance and position of a subwoofer cannot be detected. This may be caused by noise.
Try performing the measurement in a quiet environment.
Warning 44:
Measurement has been completed. However the speakers are not placed in the proper
position with respect to each other.
NO WARNING:
There is no warning information.
[170] Troubleshooting
Error messages

Network features message list

Invalid XXX (*):
The entered value is incorrect or invalid.
*
XXX represents an IP Address, Subnet Mask or Default Gateway.
[171] Troubleshooting
General

The receiver is turned off automatically.

[Auto Standby] is set to [On].
The sleep timer function was activated.
[PROTECTOR] was activated.
[FAN STOPPED] was activated.
[172] Troubleshooting
General
The receiver does not turn on after performing USB
Update or Network Update.
The USB Update or Network Update procedure may not have been completed.
While a USB flash drive containing the package file for updating the receiver is inserted,
disconnect the AC power cord (mains lead) and connect it again.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents