Sony STR-ZA5000ES User Manual page 51

Select [Zone Controls] - [Zone2 Volume] from the home menu.
5
Adjust to a suitable volume level.
6
Hint
You can also activate Zone 2 by pressing ZONE2
You can also select source signals you want to output using the input buttons while [ZONE2 INPUT -
xxxx (input name)] is shown on the display panel.
You can also adjust volume level using MASTER VOLUME on the receiver while [ZONE2 INPUT -
xxxx (input name)] is shown on the display panel.
To exit Zone 2 operation
Select [Zone Controls] - [Zone2 Power] from the home menu, then select [Off].
Available input for Zone 2 operations
See "Available input sources for each zone."
[65] Using the Multi-Zone Features Enjoying sound from speakers located in other rooms
using another amplifier
Connecting another amplifier in Zone 2/3
You can enjoy image (*) and sound from a device connected to the receiver in a zone other
than the main zone. For example, you can watch a DVD in the main zone and listen to a CD in
Zone 2.
* For a connection using the HDMI OUT B (ZONE 2) jack only
Connecting another amplifier using the ZONE 2 VIDEO/AUDIO OUT jack
TV monitor
Speakers
Other amplifier/receiver
Video cable (not supplied)
Audio cable (not supplied)
Note
The ZONE2 VIDEO OUT jack can output video signal input from the VIDEO IN jacks.
When outputting optical/coaxial audio signals, set the audio output to PCM on the connected device.
For details, refer to the operating instructions of the connected device.
Connecting another amplifier or TV in Zone 2 (with HDMI connection)
HDMI video/audio input signals, optical/coaxial audio input signals are output to Zone 2 using
the HDMI OUT B (ZONE 2) jack on the receiver.
Speakers
TV
Other amplifier/receiver
HDMI cable (not supplied)
Note
The following settings are required for this connection.
Set [HDMI Out B Mode] in the [HDMI Setup] menu to [Zone2]
Set [Zone2 Audio Out] in the [HDMI Setup] menu to [Zone2 AMP]
When outputting optical/coaxial audio signals, set the audio output to PCM on the connected device.
For details, refer to the operating instructions of the connected device.
(power) on the remote control.