Argon 18 E-119 TRI+ Assembly Manual page 34

E-119 TRI+: 11. Rear Brake Installation
23. Adjust ball plungers to needed brake pad opening (refer to table on next page).
24. Test brake, cam should easily rotate and come back to initial position.
Plunger
Note:
To make sure that cable housing and ferules are well seated in cable stops, insert
something hard between brake pads (e.g.: plier's handle) and apply force on brake
lever. if cable tension is lost, unscrew cable clamp bolt and retighten.
25. Install brake cap over assembly and tighten the 2 cap bolts to 5Nm.
Note:
To release cable from brakeset (e.g.: retightening, changing cable, etc.) lock Cam
rotation by placing hex key between cam and frame while unscrewing clamp bolt.
5Nm
33