Argon 18 E-119 TRI+ Assembly Manual page 30

E-119 TRI+: 11. Rear Brake Installation
Frame Section
Note: For easier assembly, install rear brake cable and housing before the brake assembly. outer
side
6. Measure a length of 70cm (for a medium-sized frame) KEB housing, clean both ends to avoid
cable friction.
7. Connect the E-Z Bend handlebar section to the frame KEB section of housing with cable
jointer.
8. Insert the housing inside frame and so it by-passes the bottom bracket guide and up to the
Jointer
rear brake opening.
Note: Make sure housing is not caught in front derailleur hanger insert.
9. Insert a metal cap on the cable housing end
10. Thread the cable through rear brake without inserting housing into cable stopper.
29