Argon 18 E-119 TRI+ Assembly Manual page 25

E-119 TRI+: 10. Handlebar Installation
5Nm
5Nm 5Nm
5Nm
GREASE
For an inclined position, use the swivel
4.15
assembly (4.2).
4.12.2
STEP 1: Swivel assembly content:
1- Connector base (4.12.1)
CARBON FIBER
ASSEMBLY
5Nm
2- Swivel spacer (4.2.1 + 4.2.2)
COMPOSITE
3- Swivel screw (4.2.4)
4.12.1
4- Swivel square nut (4.2.3)
LOCTITE
Assemble the unit and leave it
8Nm
4.2
unscrewed, just enough to allow
4.2.4
adjustment and to turn the swivel 90
degrees in order to have access to the
4.2.2
sleeve nuts (4.8) and fix the socket
head screw at 6Nm.
6Nm
GREASE
Tighten swivel screw (4.2.4) to 8Nm.
Note:
4.2.1
The connector base must be fixed to the
top of the swivel assembly, not on the
sleeve nuts.
4.2.3
4.1
4.8
24