Argon 18 E-119 TRI+ Assembly Manual page 31

E-119 TRI+: 11. Rear Brake Installation
11. For easier assembly, remove the bolt pivot's o'rings and remove the brake arms
from brace.
outer
side
12 Install the brake assembly fender (1.3). Push pins into brake brace until fender
touches bottom of brace.
13. Push housing inside frame while holding on to the cable and thread cable into
brake brace cable stop hole.
Brace
14. Gently insert brakeset into frame opening (careful not to kink cable).
15. Install pivot bolts and brake arms. Fully retract plunger inside brake arms to help
with assembly. Make sure 1mm washer is located underneath each brake arms.
1.3
16. Apply grease on pivot before tightening to 7Nm.
Plunger
7Nm
GREASE
30