Argon 18 E-119 TRI+ Assembly Manual page 26

E-119 TRI+: 10. Handlebar Installation
Note: Internal Di2 cabling
SM-EW90B
junction box
Make sure the Di2 cables come out
from the end of the extension bar, and
then insert them through the notches
at the center of the spacers. Make
sure the Di2 cable goes through the
bottom notch. Drop the cable in the
handlebar using the hole between the
two sleeve nuts. Run the cable inside
the handlebar until it comes out of the
large hole at the center. Then, connect
it to the SM-EW90B junction box.
25