Yealink SIP-T29G User Manual page 116

User Guide for the SIP-T29G IP Phone
Using the speakerphone

Using the headset

You can also dial the number first, and then choose the way you want to speak to the
other party.
You can also search and dial a contact from call history, local directory or remote phone
book. For more information, refer to
Management
During a call, you can alternate between Speakerphone, Headset, and Handset modes
by pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call and far-site's information (name or phone number)
are visible on the LCD screen. In the figure below, the call to ―Tom‖ (the phone number:
1002) has lasted 6 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press
The # key is configured as a send key by default. You can also set the * key as the send
key, or set neither. For more information, refer to the
Note
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone,
press the OK key when the phone is idle. The maximum length of SIP URI or IP address
length is 32 characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press
Enter the desired number using the keypad.
Press
104
Contact Management
on page 68.
, , or the Send soft key.
, or the Send soft key.
on page
Key as Send
or the line key to obtain a dial tone.
48 and Call History
on page 41.