Table of Contents
Advertisement
Read the instruction manual completely and follow all the safety
•
information before attempting to use or service this instrument.
• Wear protective clothing and gloves as required.
• Use caution on any circuit: potentially high voltages and currents
may be present and may pose a shock hazard.
• Read the safety specifications section prior to using the current
probe. Never exceed the maximum voltage ratings given.
• Safety is the responsibility of the operator. The FlexProbe
used only by qualified personnel using applicable safety precautions.
• ALWAYS de-energize the circuit before wrapping the FlexProbe
around bare conductors, bus bars, or near live parts. Do not wrap on
live conductors.
• ALWAYS connect the electronic module to the display device before
wrapping the FlexProbe
• ALWAYS inspect the module, sensor, sensor cable, and output termi-
nals prior to use. Replace any defective parts immediately. Use only
factory parts.
• NEVER use the FlexProbe
1000V CAT III and 600V CAT IV.
1.1
International Electrical Symbols
This symbol signifies that the instrument is protected by double or reinforced
insulation.
This symbol on the instrument indicates a WARNING and that the operator must
refer to the user manual for instructions before operating the instrument. In this
manual, the warning instructions above indicate that if the instructions are not
followed, bodily injury, installation/sample and product damage may result.
Risk of electric shock. The voltage at the parts marked with this symbol may be
dangerous.
This symbol refers to a type B current sensor. Do not apply around or remove from
HAZARDOUS LIVE conductors without additional protective means (de-energizing
the circuit or wearing protective clothing suitable for high voltage work).
In conformity with WEEE 2002/96/EC
FlexProbe
- Flexible AC Current Probe
®
CHAPTER 1
INTRODUCTION
WARNING
around the sample being tested.
®
on electrical conductors rated above
®
must be
®
®
1
Advertisement
Table of Contents
