Installing The Switch; Mounting The Engine - Seagull Models CHRISTEN HUSKY SEA180 Assembly Manual

Throttle servo.
THROTTLE SERVO ARM INSTALLA-
TION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
.
WWW.SEAGULLMODELS.COM
Adjustable Servo
connector
.
Servo arm
.
Throttle servo arm.
3x10 mm

INSTALLING THE SWITCH.

Install the switch into the precut hole in
the side, in the fuselage.
Recomend mounting switch inside
fuselage if using floats.
Cut Covering.
Cut .
Switch Installation.

MOUNTING THE ENGINE.

1) Position the engine with the drive
washer (145mm) forward of the firewall as
shown.
3/32'' Hole
11 11