Hinging The Elevators - Seagull Models CHRISTEN HUSKY SEA180 Assembly Manual

CHRISTEN HUSKY

HINGING THE ELEVATORS.

1) Locate the items for this section of the
manual.
2) Carefully remove the elevator from one
of the horizontal stabilizer panels. Note the
position of the hinges. Used C/A glue to fix
the hinges position.
4
Instruction Manual.
3) Remove each hinge from the horizon-
tal stabilizer panel and elevator and place a
Tpin in the center of each hunge. Slide each
hinge into the elevator until the T-pin is
snug against the elevator. This will help en-
sure an equal amount of hinge is on either
side of the hinge line when the elevator is
mounted to the horizontal stabilizer panel.
C/A glue
Epoxy
Epoxy