Setting Up Lan Drivers - NEC Express5800 Series Installation Manual

Chapter 1 Installing Windows
[N8104-186]
*1: If there are adapters with the same name, a different identification number will be assigned to xx.
3.5.2

Setting up LAN drivers

(1) Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. On the Advanced tab, set the Speed & Duplex values to the same as those of the switching hub.
4. Click OK in the Network Adapter Properties dialog box.
5. Restart the system.
The link speed setting is now complete.
(2) Setting up Wake on LAN
When using N8104-172/175/176 with the server, follow the procedure below to set it.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. Open Advanced tab, click Enable PME to show Value.
4. Change the value to Enabled by the down-arrow button.
5. Click OK, and then restart the system.
Setup is now complete.
46
Port1：HPE Ethernet 10Gb 2-port 562SFP+ Adapter #xx(*1)
Port2：HPE Ethernet 10Gb 562SFP+ Adapter #xx(*1)
Tips
The ID for N8104-173/182/183/185 might be a number of two or more digits.
This is due to the LAN driver specifications and not an error.
This number cannot be changed.
Tips
The network adaptor name displayed in the device manager may be different from
the one listed above.
In this case, the correct network adaptor name can be displayed by following the
procedure below.
1. Start Device Manager.
2. Open Network Adaptor, right click on the relevant adaptor, and select
Delete.
Do not check the Delete the driver software of this device checkbox.
3. Select Scan hardware change from Control.
Tips
If you are using a network adaptor for N8104-185, the network adaptor settings
can be set to "10 Gbps Full Duplex", and the connected switching hub settings can
be set to "Auto Negotiation".
Express5800/R110j-1 Installation Guide (Windows)
Installing Windows Server 2016