Installing / Removing Outside Lever (Key-In-Lever) Kil; Installing / Removing Outside Lever - Kaba E-PLEX Installation Instructions Manual

H. INSTALLING / REMOVING OUTSIDE LEVER
(Key-In-Lever models only)
H-1 Make certain the lever catch is up as shown (c). To
successfully install the outside lever, the lever
sleeve (f) tab must be positioned correctly with the
respective notch on the lever. The lock comes
shipped with the lever sleeve already installed in the
lock housing. When installing lever, ensure it is ori-
ented to engage the lever sleeve to accommodate
desired lock handing as shown.
H-2 Insert one of the supplied keys (a) into the outside
lever (b) and rotate key counterclockwise 45
degrees.
H-3 Insert the outside lever (b) until it is flush to the
outside unit assembly (g). Secure the outside lever
by rotating the key (a) clockwise 45 degrees to hor-
izontal position. Remove key.
Note: To remove the outside lever from the
outside unit assembly, follow the step below.
H-4 Insert one of the supplied keys (a) into the outside
lever and rotate it counterclockwise 45 degrees.
Insert release tool (d) into the small hole (e) under
lever as shown. Gently push lever catch up until it
clicks. Remove tool, then remove outside lever (b).
I. INSTALLING / REMOVING OUTSIDE
LEVER
(Interchangeable / Removable Core Models)
I-1 Make certain the lever catch is up as shown (c). To
successfully install the outside lever, the lever sleeve
(f) tab must be positioned correctly with the respec-
tive notch on the lever. The lock comes shipped with
the lever sleeve already installed in the lock housing.
When installing lever, ensure it is oriented to engage
the lever sleeve to
accommodate desired lock handing as shown.
Note: For all interchangeable/removable cylinders
except ASSA/Medeco/Yale, proceed to section I-2.
For ASSA/Medeco/Yale cylinders, skip to section I-5.
18
c
Incorrect
Correct
Position
Position
f KIL Lever Sleeve
LH
b
a
45º
a
b
45º
e
c
Incorrect
Correct
Position
Position
IC Lever Sleeve
f
LH
RH
g
g
d
RH