Table of Contents
Advertisement
OPERATIONAL NOTE:
The E-Plex Exit Trim lock is almost identical to the E-Plex 5000 Cylindrical
lock with the following exceptions:
1. Operation of the Lever When the lock's handing is properly set, only a
downward rotation of lever will actuate latch.
2. Key Override Use The key override differs in that rotating the key does
not actuate the latch. To use the key override the key must be inserted
into the cylinder and rotated counter clockwise till it stops (approximately
90 degrees) then while holding the key in this position with one hand use
the other hand to rotate the lever downward to retract the latch. Once the
lever has rotated a few degrees the key may be released.
TOOLS REQUIRED
• Safety glasses
• Electric drill (variable speed)
• Awl or center punch
• 2
⁄
" (54 mm) hole saw pilot drill
1
8
4
For technical assistance please call
1-800-849-TECH (8324) or 336-725-1331
•
⁄
" (25 mm) hole saw pilot drill
3
8
• Hammer
• Phillips head screwdriver
• Small flat blade screwdriver
Advertisement
Table of Contents
