Table of Contents
Advertisement
I-2
Insert the outside lever (b) until it is flush to the outside
unit assembly (a). To secure the outside lever, insert the
release tool (d) (or screwdriver) into the outside lever as
shown, and slide the lever catch down until it clicks. Make
certain lever is attached before installing the core.
I-3
Insert the supplied tailpiece (e) vertically into the outside
lever (b) as shown. Make certain that you rotate the tail-
piece so that it will align with the interchangeable core.
For screw cap type cylinders (Schlage) (g), the tail-
piece must be assembled to the cylinder first (vertical
position). Insert the interchangeable core into the
outside lever. Remove control key.
Note: To remove the outside lever from the
outside unit assembly, follow the steps below.
I-4
Remove the interchangeable core (g).
Then remove the tailpiece (e).
Note: You may want to use needle nose pliers
for some tailpieces.
Insert the release tool (d) into the small hole (f) under lever
as shown. Gently push lever catch up until it clicks. Remove
tool, then remove outside lever (b).
I-5
For ASSA/Medeco/Yale interchangeable/removable
cylinders, the tailpiece must be prepped for the desired
length before installation.
When using a Yale cylinder on a cylindrical
latch application, measure the door thickness
of the intended application.
I-6
Notice the score marks on the flat portion of the
ASSA/Medeco/Yale tailpiece. Using the diagram below,
locate the score mark on your tailpiece that matches your
cylinder prep for the intended application, and break the
tailpiece off accordingly.
10
YALE 6 & 7 PIN,
EXIT & MORTISE
MEDECO 5 PIN,
EXIT & MORTISE
ASSA & MEDECO 6 PIN,
EXIT & MORTISE
YALE 6 & 7 PIN,
CYLINDRICAL – THIN DOOR
(1
⁄
" (35 mm) to 1
3
8
(DO NOT SHORTEN TAILPIECE -
For 1
⁄
" (41 mm) to 2
5
8
ASSA/MEDECO 5, 6 & 7 PIN,
CYLINDRICAL – DO NOT SHORTEN TAILPIECE
a
b
d
b
e
vertical
g
b
f
d
⁄
" (38 mm))
1
2
⁄
" (57 mm))
1
4
Advertisement
Table of Contents
