Table of Contents
Advertisement
9 • Installing the key-in-knob mechanical
override model
Preparing the lever handle and cylinder for
3
installation
3. Insert the cylinder (J) without key (N) into the lever handle
(H) (see Fig.3)
Fig. 3
4. Insert plug (A) including Set Screw (K) into lever handle (H)
Fig.4
(K)
(K1)
5. Insert key (N) into cylinder (J). Hold plug (K) in position. (See
Fig. 5).
Fig. 5
Caution: If the Lever is Not Assembled with the key in the
position shown in Fig. 6 & Fig. 7, the inside mechanism
!
of the lock could be damaged if the lever is rotated and
forced.
(J)
(H)
(H)
PK 29 15 -T 07 _20 14 E- 7 60 /77 0/7 90 SE R I ES R ET R OF I T I NS T ALL AT I ON GU I DE
Steps to attach the lever handle to the
4
lock housing
*NOTE: the position of the key is
very important
6. Right-handed Lever handle: Turn the key (N) aprroximately
to 100º clockwise so that it is in the vertical position and the
recess entry for key is in the top position. (See Fig. 6)
Fig. 6
Recess entry for key in the top position
Left-handed lever handle: Turn the key (N) approximately to
100º clockwise so that it is in the vertical position and the
recess entry for key is in the bottom position. (See Fig. 7)
Fig. 7
Recess entry for key in the bottom position
The key (N) and the recess entry for key must be in the
!
positions shown in Figs 6 & 7 before placing the lever
handle on the housing or the lever and the override
mechanism will not work.
Troubleshooting:
If you have assembled the lever and housing with
the key (N) in the wrong position, the key (N) will
get stuck. To remove the key (N), turn it so that it
is in the vertical position and insert a small flat
screwdriver (T) (see page 16 Fig.10A) into the hole
under the lever handle to push Lever Catch (F) in
(N)
(see page13 Fig.2). Remove key. If it is still stuck,
turn the key 90º clockwise to the horizontal position
and push the Lever Catch (F) in again with the small
screwdriver (T). Remove key (N).
P a g e 1 4
Hide quick links:
Advertisement
Table of Contents
