Install Exit Device - Kaba E-Plex 5X10 Installation Instructions Manual

B. DOOR PREPARATION – E-PLEX EXIT TRIM
B-1 For New Installations (Existing Installations proceed
to Step B-2): Place paper template (e) (supplied) onto
the inside of the door and align with the Centerlines.
Mark the location of the E-Plex Exit Trim mounting
holes. Drill the four
door, then use a hole saw to cut the 2
bore through the door at the intersection of the
Vertical (a) and Horizontal (d)Centerlines. Care should
be taken to drill holes perpendicular to the door face.
Make sure any burrs are removed from the hole
edges, and that all chips are cleaned out of the holes
prior to installing hardware.
B-2 For Existing Installations (New Installations proceed to Section C):
Doors that have an existing exit device installed might already have a
through bore at the intersection of the Vertical and Horizontal
Centerlines, if the existing hole is smaller than 2
it will need to be enlarged. Extra care should be used to ensure that the
location of this hole is kept as accurate as possible in relation to the exist-
ing mounting pattern. Place paper template (supplied) onto the inside of
the door aligned with the reference lines and mark the location of the E-
Plex Exit Trim mounting holes. Drill the four
the door, then use a hole saw to cut the 2
the intersection of the Vertical and Horizontal Centerlines. Care should be
taken to drill holes perpendicular to the door face. Make sure any burrs
are removed from the hole edges, and that all chips are cleaned out of
the holes prior to installing hardware.
C. INSTALL EXIT DEVICE:
Follow the exit device manufacturer's instructions for installing the exit
device onto the door.
6
⁄ " (10 mm) (b) holes through the
3
8
⁄ " (54 mm) (c)
1
8
⁄ " (54 mm) in diameter
1
8
⁄ " ( 10 mm) holes through
3
8
1 ⁄ " bore through the door at
8
a
b
d
c
e