Tab: Setup - Toshiba 4400 Series Installation And Operation Manual

12.15 Tab: Setup

The SETUP tab allows the user to adjust certain UPS parameters. The setup tab shows 12 buttons.
Inactive buttons are indicated with a "x" in the lower right-hand corner of the button. The table below,
right, shows a typical SETUP button.
4400 Series UPS
SETUP
ASYN
Param.
Prefix
0 UPS Identification, Serial number, Start-up Date, software version
1 Input line-line and line-neutral V/I values, V/I percent of rated value, and frequency
2 Output line-line and line-neutral V/I values, V/I percent of rated value, and frequency
3 Bypass line-line and line-neutral V/I values, V/I percent of rated value, and frequency
4 DC Bus Voltage, DC Under Voltage Level, Startup Voltage Level
5 Battery Voltage/Current, shutdown voltage, battery test enable
6 Control and Configuration – UPS time/date/status, faults, warnings, password manage-
ment
7 UPS Operation time, Number of Faults, Backup, Operations.
8 Display and Ext Comm. – Disp. S/W version, buzzer status, display calibration values.
RemotEye I/P address, data and network status.
80
Parameter Category
FIGURE 12.14 – PARAMETER CATEGORIES
4400 Series Installation and Operation Manual – 64527-006
Typical Significance
Button
No "x" in the lower right corner
indicates the button is active.
Pressing the button will open
a data page displaying the
parameters available at the
current security level.
A button that has an "x" in the
lower right corner is inactive
and cannot be accessed at the
current security level.
ASYN