Table of Contents
Advertisement
12.15
Tab: Setup
The SETUP tab allows the user to adjust certain UPS parameters. The setup tab shows 12 buttons.
Inactive buttons are indicated with a "x" in the lower right-hand corner of the button. The table below,
right, shows a typical SETUP button.
SETUP
Param.
Prefix
0
UPS Identification, Serial number, Start-up Date, software version
1
Input line-line and line-neutral V/I values, V/I percent of rated value, and frequency
2
Output line-line and line-neutral V/I values, V/I percent of rated value, and frequency
3
Bypass line-line and line-neutral V/I values, V/I percent of rated value, and frequency
4
DC Bus Voltage, DC Under Voltage Level, Startup Voltage Level
5
Battery Voltage/Current, shutdown voltage, battery test enable
6
Control and Configuration - UPS time/date/status, faults, warnings, password management
7
UPS Operation time, Number of Faults, Backup, Operations.
8
Display and Ext Comm. - Disp. S/W version, buzzer status, display calibration values.
RemotEye I/P address, data and network status.
46
Parameter Category
FIGURE 12.13 - PARAMETER CATEGORIES
Typical
Significance
Button
No "x" in the lower right corner
indicates the button is active.
Pressing the button will open
a data page displaying the
parameters available at the
current security level.
A button that has an "x" in the
lower right corner is inactive
and cannot be accessed at the
current security level.
4300 Series Installation and Operation Manual
Advertisement
Table of Contents
