Carefully inspect the UPS for shipping damage. Units shipped within North America and NAFTA are
shrink wrapped.
4. Attach the rails as shown to the front of
the pallet.
5
Use the four 1/2 x 3" bolts to secure the
rails to the shipping pallet.
6. Place the tie brackets in the slots at the
upper and lower ends of the ramps.
7
SLOWLY roll the unit down the ramp.
8. Save the loading rails for anchoring of
the UPS. See Section 8.3.
8
1. Remove shrink wrap.
2. Unbolt the rails from
both the unit and the
shipping pallet.
3. Place the rails on the
front of the pallet.
FIGURE 4.1 – UNSHIPPING 15-30KVA UPS
4400 Series Installation and Operation Manual – 64527-006