Table of Contents
Advertisement
VERTICAL CONTACT TOASTER
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the included large box. It should contain
the following:
• bun chute (Figure 1)
• release sheets (Figure 2)
• owner's manual
3. Remove all shipping tape and protective cover-
ings from the unit and parts.
NOTE: If any parts are missing or damaged, contact
Antunes Technical Service IMMEDIATELY at 1-877-
392-7854 or 630-784-1000.
Assembling the Unit
1. Remove bun chute from the additional box and
install (Figure 1.)
2. Remove the release sheet from the plastic bag
and lay it on a clean, flat surface. Fold the sheet
exactly in half (Figure 2).
3. Crease the sheet at the fold using only your fin-
gers (Figure 2).
IMPORTANT: Do not use metal tools to crease the
release sheet.
4. Install the release sheet by draping it over both
sides of the platen surface. The crease should
be centered directly on top of the platen
5. Install the heat shield. The heat shield clips fit
over the top of the platen securing the release
sheet (Figure 3).
6. Install Bun feeder on the top of the unit.
NOTE: Check the release sheet to make sure it is not
caught in the conveyor. Additional release sheets can
be obtained through your authorized service agency
under part no. 7000249 (3 pack) or 7000250 (10 pack).
IMPORTANT: Make sure heat shield assy. is acti-
vating (depressing) the conveyor interlock switch
(see Figure 3). The conveyors will not rotate
unless the heat shield is in place and interlock
switch is activated (depressed).
INSTALLATION
7. Install power cord to the bottom of unit (Figure 1)
(Mfg. No. 9200580 only).
Bun Chute Assy.
connected over
bottom rear sup-
port rod
Conveyor
Cover Assy.
.
(Figure 3)
Fold over so ends meet
Failure to use release sheets may result in dam-
age to the unit and loss of warranty coverage.
6
Power Cord
Receptacle (L6-30R)
Bun Chute
(Mfg. No. 9200580)
(Mfg. No. 9200580)
Figure 1. Installing Bun Chute
Lay sheet on a flat surface
Press lightly with finger to
form crease
Figure 2. Folding Release Sheet
CAUTION
P/N 1010747 Rev. G 11/15
Bun Feeder
#9200582 only
Heat Shield
Conveyor
Cover Assy.
Advertisement
Table of Contents
