Table of Contents
Advertisement
INSTALLATION
1.
Remove unit and all packing mate-
rials from shipping carton.
2.
Open the Accessories Box. It should
contain the following:
•
Bun Chute
•
Bun Feeder
•
1 Belt Set
•
Owner's Manual
NOTE:
If any parts are missing or dam-
aged, contact Antunes Techni-
cal Service IMMEDIATELY at
1-877-392-7854 or 1-630-784-
1000.
3.
Remove all packing materials and
protective coverings from the unit.
4.
Wipe the entire exterior of the
toaster and the accessories men-
tioned above with a hot damp
cloth. Allow to air dry
NOTE:
Do NOT use a dripping wet
cloth. Wring out before use.
5.
Attach the Bun Chute and Bun
Feeder.
When placing the toaster into service,
pay attention to the following guidelines.
Make sure the power switch is off
y
and the unit is at room temperature
before plugging in the power cord.
Do not block or cover any
y
openings on the unit.
y
Do not immerse the power
cord or plug in water.
Keep the power cord away
y
from heated surfaces.
Do not allow the power cord to
y
hang over edge of table or counter.
Place the unit on a sturdy, level
y
table or other work surface..
Turn the power switch to
y
off (if it is set to on).
Ensure the line voltage cor-
y
responds to the stated voltage
on the specification label and
power cord warning tag.
Plug the power cord into the
y
appropriate power outlet. Re-
fer to the specification plate
for the proper voltage.
P/N 1011189 Rev. B 07/14
OPERATION
1.
Turn the unit on and allow it to
warm up until USE appears in the
display
2.
Drop product into the appropriate
lane on the Bun Feeder according
to Bun Feeder labels. Insert buns
with the cut side facing away from
the front of the toaster
3.
Finished product drops into the bun
landing zone.
LIGHT/DARK ADJUSTMENTS
The light/dark value can be adjusted when
the unit is displaying "USE". To adjust the
light/dark value, press the LIGHTER or
DARKER button. The display will change to
show the current light/dark value.
NOTE:
The default light/dark value is
d0.
Press the LIGHTER or DARKER buttons to
change the light/dark value. The adjust-
ment range is L1-L9 and d0-d9. L9 is the
lightest, d0 is the middle, and d9 is the
darkest setting.
To save the light/dark value, press the PRO-
GRAM button or wait 5 seconds until the
screen displays "USE".
NOTE:
Adjusting the light/dark value
does NOT change the tempera-
ture. It changes the speed of the
conveyors. The light/dark value
will reset to the d0 value when
the unit is turned off.
5
Figure 1.
Advertisement
Table of Contents
