Installation; Unpacking; Location - Roundup GST-5V Owner's Manual

INSTALLATION

Unpacking

1. Open the large box. It contains:
• GST-5V toaster
• Accessories box
2.
Remove the accessories box from the
large box.
3.
With the help of another person,
carefully remove the GST-5V from
the large box.
4. Remove all protective coverings
from the unit.
5. Open the Accessories Box. It con-
tains:
• Owner's Manual
• Bun Buffer Frame
6.
Wipe the entire exterior of the
toaster and the accessories men-
tioned above with a clean towel
sprayed with an approved sanitizer.
Allow to air dry.
NOTE: Handle accessories with care. If
an accessory becomes bent or
damaged, it may not attach to
the unit correctly, which may af-
fect normal operation.
NOTE: If any parts are missing or dam-
aged, contact A.J. Antunes Tech-
nical Service IMMEDIATELY at
1-877-392-7854 (North America
only), or 630-784-1000.

Location

When placing the toaster into service, pay
attention to the following guidelines:
Make sure power is off and the
y
toaster is at room temperature.
Do NOT block or cover any
y
openings on the unit.
Do NOT immerse cord
y
or plug in water.
Keep cord away from heated surfaces.
y
Do NOT allow cord to hang over
y
edge of table or counter.
1.
Place the toaster in the required
position.
2.
Attach the Bun Feeder and Bun Buf-
fer Frame accessories (Figure 1).
3. Attach the optional Top Feeder if
present (Figure 1).
4. Plug the power cord into an ap-
propriate power outlet. Refer to the
specification plate for
the proper voltage.
P/N 1011263 Rev. C 12/15
REAR
CONVEYOR
COVER
COMPRESSION
KNOB
FRONT
CONVEYOR
COVER
Figure 1. GST-5V Components (Belts not Shown)
5
OPTIONAL TOP FEEDER
(AVAILABLE FOR PURCHASE SEPARATELY)
BUN FEEDER
CONTROL
PANEL
BUN BUFFER
FRAME