Advertisement

Manufacturing Numbers 9210600/602/604/609/612/618/620/622
Place this manual in the Toaster section
of your Equipment Manual.
Manufactured exclusively for
McDONALD'S ®
A.J. ANTUNES & CO.
180 KEHOE BLVD.
CAROL STREAM, ILLINOIS 60188, U.S.A.
PHONE: 1-630-784-1000
TOLL FREE: 1-877-392-7854
FAX: 1-630-784-1650
www.ajantunes.com
Owner Information ...............................................................2
General .............................................................................. 2
Warranty Information.......................................................... 2
Service/Technical Assistance ............................................. 2
Model Designation ............................................................. 3
Model Specifications .......................................................... 3
Specifications .......................................................................3
Toasting Time Change ....................................................... 3
Electrical Cord & Plug Configurations................................ 3
Weights .............................................................................. 4
Dimensions ........................................................................ 4
Important Safety Information ..............................................5
Assembling the Unit ........................................................... 6
Unpacking .......................................................................... 6
Installation.............................................................................6
Location.............................................................................. 6
Operation...............................................................................7
Operating Instructions ........................................................ 7
Toaster Operation............................................................... 8
The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald's Equipment
manufactured and purchased after January 1, 2003.
All components are warranted against defects in the material and workmanship for a period of two (2) years from date of original installation, not to exceed 30 months
from date of shipment from our factory.
If any part becomes defective during the first two (2) years after the original installation date, Antunes Food Service will pay negotiated straight time labor costs to an
Authorized Service Agent to replace the part, plus travel expenses up to 50 miles/80 km, 1 hour each way (100 miles/160 km, 2 hours round trip).
WARRANTY EXCLUSIONS
• The cost of Installation.
• Equipment that has been damaged due to shipment. Purchaser should
make damage claim directly upon carrier.
• Alteration, misuse, abuse.
• Improper storage or handling.
• Improper maintenance.
• Failure to follow proper Installation instructions, including electrical connec-
tion.
• Improper or unauthorized repairs.
Antunes Food Service reserves the right to make changes in design or add improvements on any products. The right is always reserved to modify Equipment
because of factors beyond our control and government regulation. Changes to Equipment do not constitute a warranty charge.
This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular pur-
pose, each of which is expressly disclaimed. The remedies described above are exclusive, and in no event shall A.J. Antunes & Co. or any of its Divisions be liable
for special consequential or incidental damages for the breach or delay in the performance of this warranty.
This manual is for the exclusive use of licensees and employees of McDonald's Systems, Inc.. © McDonald's Corporation All Rights Reserved
P/N 1010776 Rev. H 03/04
McDonald's
RAPID TOASTER
MODEL VCT-250
BY
��

TABLE OF CONTENTS

LIMITED WARRANTY
RAPID TOASTER VCT-250
Safety Features.................................................................. 9
Maintenance........................................................................11
Daily Cleaning ...................................................................11
Monthly: Bun Temperature Test ....................................... 12
Temperature of Bun Landing Area. ................................. 12
Replacing Groovy Belt Wraps ......................................... 14
Install New Release Sheet (monthly)............................... 15
Assemblies ....................................................................... 15
Troubleshooting .................................................................16
Optional Accessories.........................................................25
NOTES .................................................................................28
• Scheduled Maintenance procedures as outlined in your MRC Card.
• Consumables such as Grill Covers (Release Sheets), gaskets, Conveyor Belt
Wraps, O-Rings, and light bulbs.
• Overtime or Holiday charges.
• Mileage over 50 miles/80 km (100 miles/160 km round-trip), or travel time
over two (2) hours.
• Fright, foreign, excise, municipal or other sales or use taxes.
• Consequential damages such as loss of profit, loss of time, the cost of repair-
ing or replacing other property which is damaged, or any other incidental
damage of any kind.
1

Advertisement

Table of Contents
loading

Summary of Contents for Roundup VCT-250

  • Page 1: Table Of Contents

    RAPID TOASTER MODEL VCT-250 RAPID TOASTER VCT-250 Manufacturing Numbers 9210600/602/604/609/612/618/620/622 Place this manual in the Toaster section of your Equipment Manual. Manufactured exclusively for McDONALD’S ® A.J. ANTUNES & CO. 180 KEHOE BLVD. CAROL STREAM, ILLINOIS 60188, U.S.A. PHONE: 1-630-784-1000...
  • Page 2: Owner Information

    Address: The warranty does not extend to: Use only genuine Roundup replacement parts in this • Damages caused in shipment or damage as unit. Use of replacement parts other than those sup- a result of improper use.
  • Page 3: Model Designation

    RAPID TOASTER VCT-250 SPECIFICATIONS Electrical Cord & Plug Configurations Model Designation Letter Description Configuration VCT-250XX Code* TYPE OF POWER CORD Commercial Cord H = HARMONIZED Harmonized Cord C = COMMERCIAL Rockbestos Cord R = ROCKBESTOS (H)C** CEE 7/7, 16 Amp.,...
  • Page 4: Weights

    RAPID TOASTER VCT-250 SPECIFICATIONS (continued) Dimensions Weights 43.1 Shipping 47.6 P/N 1010776 Rev. H 03/04 McDonald’s...
  • Page 5: Important Safety Information

    RAPID TOASTER VCT-250 IMPORTANT SAFETY INFORMATION Throughout this manual, you will find the following safety words and symbols that signify important safety issues with regards to operating or maintaining the equipment. WARNING WARNING GENERAL WARNING. Indicates informa- ELECTRICAL WARNING. Indicates infor- tion important to the proper operation of the mation relating to possible shock hazard.
  • Page 6: Assembling The Unit

    RAPID TOASTER VCT-250 INSTALLATION Location Unpacking When placing the toaster into service, pay attention to 1. Remove unit and all packing materials from the following guidelines. shipping carton. • Make sure power to the unit is off and the toaster 2.
  • Page 7: Operation

    RAPID TOASTER VCT-250 OPERATION Operating Instructions ����� ��������� 1. Set the Bun Thickness Adjustment Controls � � � � (Figure 2A & 2B) as follows: • For Mfg# 9210600 to 9210604 and 9210618 to � � � � � 9210622, set the Crown control to 5 = 13/16”...
  • Page 8: Toaster Operation

    RAPID TOASTER VCT-250 OPERATION (continued) Toaster Operation “Heat On” LED will blink on/off during warm-up and when either platen or auxiliary heaters are calling for heat. The Rapid Toaster uses a Platen Heater and two Auxiliary Heaters. The Platen Heater consists of a...
  • Page 9: Safety Features

    RAPID TOASTER VCT-250 NOTE: If no change is made within 5 seconds, the display will revert back to the previous setpoint. AUXILIARY HEATER TEMPERATURE ADJUSTMENT 1. Turn the unit ON and wait for temperature display to finish the power up sequence (Figure 4, num- bers 3 &...
  • Page 10 RAPID TOASTER VCT-250 OPERATION (continued) FAULT MESSAGES (continued) “CHEC” will flash when control compartment chec • The temperature controller has an ambient ambient temperature is exces- temperature sensor that will shut off all heating sive: 140°F (60°C) to 180°F circuits if the control compartment ambient (82°C).
  • Page 11: Maintenance

    RAPID TOASTER VCT-250 MAINTENANCE WARNING Bun Feeder Clip Turn the unit off, disconnect the power source and allow the unit to cool down before performing any ser- Bun Feeder vice or maintenance on the unit. Daily Cleaning Platen Release Sheet NOTE: Also refer to TS 019 Card (P/N 1010732).
  • Page 12: Monthly: Bun Temperature Test

    RAPID TOASTER VCT-250 Rear (Crown) Bun Feeder Conveyor Cover Bun Chute Front (Heel) Conveyor Cover Figure 11. Replacing Groovy Belt P/N 1010776 Rev. H 03/04 McDonald’s...
  • Page 13: Measure The Conveyor Belt Chains For Stretch

    RAPID TOASTER VCT-250 MAINTENANCE (continued) Measure the Conveyor Belt Chains for Stretch After a period of time, the Conveyor Belt Chain links will wear and the conveyor will stretch. This may cause the conveyor to jam as it rotates on the sprock- ets.
  • Page 14: Replacing Groovy Belt Wraps

    RAPID TOASTER VCT-250 MAINTENANCE (continued) Replacing Groovy Belt Wraps NOTE: Follow Steps 1-3, page 12 if necessary. 1. Locate the Hinge Flap on the Groovy Belt Wrap, if the Hinge Flap is not visible; plug in the power cord and turn the unit on, press down on both Conveyor Safety Interlock Switches (Figure 11) and wait until the flap is exposed and centered.
  • Page 15: Install New Release Sheet (Monthly)

    RAPID TOASTER VCT-250 MAINTENANCE (continued) Install New Release Sheet (monthly) 2. Replace Roller Tensioner assembly and reas- semble. CAUTION 3. Make sure the spacers are placed inside the Failure to use Release Sheets will result in damage to tensioner arm. The spacers are smaller than the the unit and loss of warranty coverage.
  • Page 16: Troubleshooting

    RAPID TOASTER VCT-250 TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests. Live circuits will be exposed.
  • Page 17 RAPID TOASTER VCT-250 TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Conveyor Belt Chain does Compression Knobs set incor- Set the Bun Thickness Compression Controls to “D & 5” (for Mfg# 9210600, 602, 604, 618, 620, not turn or skips sprock- rectly.
  • Page 18 RAPID TOASTER VCT-250 TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Groovy Belt Wrap Groovy Belt Wrap is installed Check that Groovy Belt Wrap is not placed over the does not fit, is difficult improperly. upper or lower Support Rod. Be sure the open end...
  • Page 19 RAPID TOASTER VCT-250 TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Buns sticking. Compression Knobs set incorrectly. Set the Bun Thickness Compression Controls to “D & 5” (for Mfg# 9210600, 602, 604, 618, 620, & 622). For Mfg# 9210609 to 9210612, set the controls to “B & 3.” See Figures 2A and 2B.
  • Page 20 RAPID TOASTER VCT-250 REPLACEMENT PARTS � �� �� �� �� �� �� � � �� � �� �� �� �� � �� �� � �� �� � � �� �� � �� �� � �� �� �� �� � ��...
  • Page 21 RAPID TOASTER VCT-250 REPLACEMENT PARTS (continued) � ���� ������� � ��� � ���� ����� ������� �������� �������������� ������ ������� ����� ������� ����� ����� ����� ������� ���������� ��� ����� ������������� ����� ��� ����������� �� � ���� ������� ����� ��� ����������� ������� ������� �� ��� ��� ����� ���� ��� ���...
  • Page 22 RAPID TOASTER VCT-250 REPLACEMENT PARTS (continued) �� �� � � � � � � � � � �� �� �� � �� � � � �� � �� �� � �� �� � �� � � � �� �� ��...
  • Page 23 RAPID TOASTER VCT-250 Item Part No. Description Qty. Item Part No. Description Qty. 0011266 Conveyor Belt Assy. (Crown) A&B 2100253 Knob, Control 0800204 1/2” Pitch Link, Small 7000232 Cover, End 0800121 3/4” Pitch Link, Large 4050214 Thermocouple Assy. (Platen) 0011264 Conveyor Belt Assy.
  • Page 24 RAPID TOASTER VCT-250 REPLACEMENT PARTS (continued) Parts Identification Axial Fan Auxiliary Heater Interlock Switch Drive Chain Idler Sprocket Transformer (5/16” Bore) Drive Sprocket (1/2” Bore) Drive Sprocket (1/2” Bore) Auxiliary Relay Platen Relay Temperature Control Position of 3 RPM Motor Position of 9 RPM Motor Drive Motor Assy.
  • Page 25: Bun Buffer Landing Zone (Accessory) The Optional Bun Buffer Landing Zone Consists Of The Following Parts

    RAPID TOASTER VCT-250 OPTIONAL ACCESSORIES There is also a kit for the Bun Buffer Landing Zone Bun Buffer Landing Zone (Accessory) available for purchase. It consists of the following parts: optional Bun Buffer Landing Zone consists of the follow- ing parts: 1.
  • Page 26 RAPID TOASTER VCT-250 WIRING DIAGRAMS Pictorial Wiring Diagram P/N 1010776 Rev. H 03/04 McDonald’s...
  • Page 27 RAPID TOASTER VCT-250 Ladder Wiring Diagram HI-LIMIT CONTROL P/N 1010776 Rev. H 03/04 McDonald’s...
  • Page 28: Notes

    RAPID TOASTER VCT-250 NOTES P/N 1010776 Rev. H 03/04 McDonald’s...

This manual is also suitable for:

Vct-250rdVct-250rrVct-250hiVct-250rs

Table of Contents