Installation And Setup; Unpacking; Assembling The Unit; Equipment Setup - Roundup VCT-2000 Owner's Manual

Vertical contact toaster
Hide thumbs Also See for VCT-2000:
Table of Contents

Advertisement

VERTICAL CONTACT TOASTER

Unpacking

1. Remove unit and all packing materials from ship-
ping carton.
2. Open the included large box. It should contain
the following:
• Bun Chute (Figure 1)
• Release Sheets (Figure 1)
• Owner's Manual
3. Remove all shipping tape and protective cover-
ings from the unit and parts.
NOTE: If any parts are missing or damaged, con-
tact Roundup Technical Service IMMEDIATELY at
1-877-392-7854 (North America only) or 630-784-
1000.

Assembling the Unit

NOTE: The factory has pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
1. Remove the Bun Chute from the additional box
and install (Figure 1).
IMPORTANT: Make sure Heat Shield assembly is
activating the Conveyor Safety Interlock Switch
(see Figure 1). The conveyors will not rotate
unless the Heat Shield is in place and Conveyor
Safety Interlock switch is activated.

INSTALLATION AND SETUP

6
Conveyor
Cover Assy.
Bun Chute
Figure 1. Installing Bun Chute
Heat Shield
Conveyor
Cover Assy.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents