If you experience any problems with the Information Warranty in this manual. installation or operation of your unit, Service/Technical contact your local Roundup Authorized If the unit arrives damaged, contact Assistance Service Agency. the carrier immediately and file a dam- Important Safety age claim with them.
IMPORTANT SAFETY WARNINGS INFORMATION Be advised of the following warnings when operating and performing mainte- Use the following guidelines for safe op- nance on this unit. eration of the unit. If the supply cord is damaged, it Read all instructions be- must be replaced by the manu- fore using equipment.
OPERATION Light/Dark Adjustments INSTALLATION The light/dark value can be adjusted when Press and release the Power button Remove unit and all packing mate- the unit is displaying “USE”. To adjust the to turn the toaster on. Allow the rials from shipping carton. light/dark value, press the LIGHTER or toaster to warm up until USE ap- Open the Accessories Box.
USER MODE Fault Messages NOTE: The Motor Speed is adjustable from 1-100. The recommended The unit displays fault messages when setting is 57. User Mode allows an operator to view the there is a problem with the unit. toaster settings but does not permit any Press the PROGRAM button to pro- “Hi”...
DAILY CLEANING NOTE: Be sure to clean and sanitize To lock out the Bottom Roller, face the Belts completely. Failure the front of the toaster. Use both Press and release the Power button to properly clean the Belts will hands and push in on the Bottom to turn the toaster off.
Page 8
Return the Top and Bottom Belt Rollers to full tension by sliding them back into place. Slowly close the rear Belt Frame Lock so the Front and Rear Belt Roll- ers lock into place. Re-engage the front Belt Frame Lock by lifting up and then locking it in place on the Front Conveyor Assembly.
TROUBLESHOOTING Problem Possible Cause Corrective Action Control Display flashes PLt Platen temperature is below 545 °F (285 °C). Allow the unit to warm up for 30 minutes and then recheck. If the Control Display still flashes PLt, contact your maintenance person continuously.
Page 10
Problem Possible Cause Corrective Action Control Display is blank. Power Cord is not plugged in. Plug the Power Cord into the appropriate outlet. Turn the toaster on. If the Control Display is still blank, contact your maintenance person or Authorized Service Agency for service. Circuit Breakers turned off or tripped.
WIRING DIAGRAM WIRING DIAGRAM WIRE LEGEND POWER 12 GA CORD 14 GA TEFLON # 18 GA 20 GA ∆ 22 GA # GRN MOV1 # WIRE NUMBER CONTROL BOARD 12V J6 TC2 PLATEN 208/240 J2 TC2 AC PWR 8888 12VAC J4 HI-LIMIT 15VA TC1 NOT USED...
Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. Roundup reserves the right to make changes in design or add any improvements on any product. The right is always re- served to modify equipment because of factors beyond our control and government regulations.