Installation; Operation - Roundup GST-2H Instruction Manual

INSTALLATION

1.
Remove unit and all packing mate-
rials from shipping carton.
2.
Open the Accessories Box. It should
contain the following:
a. Bun Chute
b. Bun Feeder
c. 1 Belt Set
d. Owner's Manual
NOTE: If any parts are missing or dam-
aged, contact Antunes Techni-
cal Service IMMEDIATELY at
1-877-392-7854 or 1-630-784-
1000.
3.
Open the side door (Figure 1) and
remove all of the plastic ties secur-
ing the toaster mechanism.
4.
Remove all packing materials and
protective coverings from the unit.
5. Wipe the entire exterior of the
toaster and the accessories men-
tioned above with a hot damp
cloth. Allow to air dry
NOTE: Do NOT use a dripping wet
cloth. Wring out before use.
6.
Attach the Bun Chute, Bun Feeder,
and Butter Wheel assembly.
7. Make sure the Compression Knob
is set to 3, the default setting.
When placing the toaster into service,
pay attention to the following guidelines.
The power cord is located at the
y
bottom of the unit. The unit is
designed to be placed on a table
that will NOT pinch the power cord.
y Make sure the power switch is off
and the unit is at room temperature
before plugging in the power cord.
y Do not block or cover any
openings on the unit.
Do not immerse the power
y
cord or plug in water.
y Keep the power cord away
from heated surfaces.
Do not allow the power cord to
y
hang over edge of table or counter.
y Place the unit on a sturdy, level
table or other work surface.
Turn the power switch to
y
off (if it is set to on).
Ensure the line voltage cor-
y
responds to the stated voltage
on the specification label and
power cord warning tag.
8.
Plug the power cord into the ap-
propriate power outlet. Refer to the
specification plate for the proper
voltage.
P/N 1011283 Rev. A 03/15

OPERATION

1.
Press and release the Power button
to turn the toaster on. Allow the
toaster to warm up until USE ap-
pears in the display
2. Set the Compression Knobs to the
desired setting. The recommended
Compression Settings are:
CROWN - #4
HEEL - #3
3. Insert product into the appropriate
lane on the Bun Feeder according
to Bun Feeder labels. Insert buns
with the cut side facing down.
4. Finished product drops into the bun
landing zone.
5
Light/Dark Adjustments
The light/dark value can be adjusted when
the unit is displaying "USE". To adjust the
light/dark value, press the LIGHTER or
DARKER button. The display will change to
show the current light/dark value.
NOTE: The default light/dark value is
d0.
Press the LIGHTER or DARKER buttons to
change the light/dark value. The adjust-
ment range is L1-L9 and d0-d9. L9 is the
lightest, d0 is the middle, and d9 is the
darkest setting.
To save the light/dark value, press the PRO-
GRAM button or wait 5 seconds until the
screen displays "USE".
NOTE: Adjusting the light/dark value
does NOT change the tempera-
ture. It changes the speed of the
conveyors. The light/dark value
will reset to the default value of
d0 when the unit is turned off.
Figure 1.