Installation; Unpacking; Equipment Setup; Assembling The Unit - Roundup VCT-2010 Owner's Manual

Unpacking

1. Remove the unit and all packing materials from
the shipping carton.
2. Open the Accessories Box. It should contain the
following:
• Bun Chute
• Two Release Sheets
• Owner's Manual
• Authorized Service Agency Directory
3. Remove all shipping tape and protective cover-
ings from the unit and parts.
NOTE: If any parts are missing or damaged,
contact Antunes Technical Service IMMEDIATELY at
1-877-392-7854 (toll free in the U.S.) or 630-784-1000.

Equipment Setup

Before placing the toaster into service, pay attention to
the following guidelines:
• Make sure power is off and the toaster is at room
temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse the power cord or plug in water.
• Keep the power cord away from heated surfaces.
• Do NOT allow the power cord to hang over the
edge of a table or counter.
• Connect the unit to the proper power supply.
Refer to the specification plate for the proper
voltage.
CAUTION
Bread may burn. Therefore toasters must NOT be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe
operating distances may cause discoloration or
combustion.
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
P/N 1011233 Rev. B 09/13
VERTICAL CONTACT TOASTER

INSTALLATION

Assembling the Unit

NOTE: The factory has pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
1. Place the unit on a flat, sturdy location.
2. Install the Bun Chute so the hooks are installed
over the lower rear yellow Support Rod (Figure 2).
IMPORTANT: Do NOT plug any other power cords
into the receptacles on the toaster.
NOTE: Make sure the Heat Shield is activating the
Conveyor Safety Interlock Switch. The unit will not
function unless the Heat Shield is in place and the
Conveyor Safety Interlock Switch is activated.
Side view of
Bun Chute connected
over the bottom
rear support rod
7
Crown Side
Bun Chute
Power
Switch
Temperature Controls &
Temperature Display
Figure 2. VCT-2010 Components
Heel Side
Hi-Limit
Control