Maintenance; Daily - Roundup VCT-20 Deluxe Owner's Manual

VERTICAL CONTACT TOASTER
WARNING
Turn the unit off, disconnect the power source
and allow the unit to cool down before performing
any service or maintenance on the unit.
CAUTION
To prevent damage to the unit, do not use abra-
sive cleaners on the release sheet or belt wrap.
CAUTION
Failure to use release sheets may result in dam-
age to the unit and loss of warranty coverage.

Daily

CLEANING THE BLACK RELEASE SHEET, CONVEYOR
BELT WRAPS AND TOASTER
Tools Required:
• Heat resistant gloves
• Clean, sanitized towels
• Scrub brush with Sanitizer Solution
1. Turn Rocker Switch (power on/off) to OFF, and
allow the unit to cool sufficiently to handle.
2. Put on protective gloves. Remove Heat Shield,
Bun Feeder, and Bun Chute. (Figure 12).
3. Remove the Release Sheet. Wipe both sides of
the Release Sheet with a clean towel and a warm
sanitizer solution and allow to air dry.
4. Turn Rocker Switch (power on/off) to ON.
5. Depress and hold the activation button with one
hand. Use your other hand, hold the scrub brush
after dipping in sanitizer solution (Figure 12).
6. Use a back and forth motion covering the belt
surface for 20 seconds per side (two rotations of
the belt flap). Repeat on second belt (Figure 12)

MAINTENANCE

7 Turn Rocker Switch (power on/off) to OFF and
unplug the power cord.
8. Wipe down the outside of the toaster and all the
parts with a clean, damp, sanitized towel and
allow to air dry.
9. Install the Release Sheet by draping it over both
sides of the Platen with the crease centered
directly on the Platen.
10. Install Bun Chute so hooks are installed over the
lower rear support rod. Install the Bun Feeder
and then install the Heat Shield aligning clips
over platen (Figure 3).
Cleaning Brush used in
a SIDE to SIDE motion
Conveyor
Cover Assy.
Bun Chute
9200580 (ONLY)
12
Figure 9. Components
P/N 1010747 Rev. G 11/15
Bun Feeder
#9200582
only
Heat Shield
Release
Sheet
Conveyor
Cover Assy.
Interlock Switch
Power Cord
9200580 (ONLY)