Information ..........3 the finest materials available and is Warnings ...........3 Fill in the information in the next assembled to Roundup’s strict quality Specifications ..........4 column and have it handy when calling standards. This toaster was tested at the Installation ..........5 for assistance.
IMPORTANT SAFETY y The equipment should be y Electrical ground is re- grounded according to local quired on this appliance. INFORMATION electrical codes to prevent the y Check with a qualified electrician possibility of electrical shock. It Use the following guidelines for safe if you are unsure if the appli- requires a grounded receptacle operation of the unit.
INSTALLATION NOTE: Do not wash the Release When placing the unit into service, pay attention to the following guidelines. Sheet or Release Sheet Re- NOTE: When placing the toaster tainers in the sink. These y Make sure to provide at into service, make sure to must be washed by hand.
INSTALLING THE RELEASE SHEET BUN THICKNESS COMPRESSION KNOB SETTINGS The Release Sheet allows buns to pass through the toaster without sticking. The toaster should never be The toaster uses two Bun Thickness operated without a clean Release Sheet installed. Compression Knobs for proper toasting of buns (heels and crowns).
OPERATING TOASTING PRODUCT INSTRUCTIONS Facing the front of the unit, insert prod- uct as described: NOTE: If the toasting quality needs y Insert Crowns into the front lane adjustment, refer to Adjusting with the cut side facing in. Toasting Quality in the Opera- 8888 y Insert Heels into the rear lane tion section of this manual.
ADJUSTING TOAST QUALITY HI LIMIT RESET BUTTON The unit can be adjusted to provide a A hi-limit control turns off power to lighter or more darkly toasted product. the unit if it overheats. To reset this Hi- Limit control, allow sufficient time (10- The lightest setting is 1 and the darkest 15 minutes) for the unit to cool down, setting is 10.
MAINTENANCE Cleaning the Release Sheet Figure 4 1. Inspect the Release Sheet. WARNING Replace the Release Sheet if The unit will remain hot while it is cooling it is worn, creased, or torn. down. Personal injury and burns may result 2.
TROUBLESHOOTING Problem Possible Cause Corrective Action Power cord not plugged in Plug power cord into the proper electrical outlet Allow unit to cool and reset the Hi-Limit Control. If it trips again, contact your Hi-Limit has tripped Maintenance person or Authorized Service Agency. No Control Display Circuit breakers turned off or tripped.
LIMITED WARRANTY Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest ma- terials available and manufactured to high quality standards. These units are warranted to be free from electrical and mechan- ical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.