Operation; Changing Channels; Info Banner; Selection Of Audio Language - Strong SRT 3000 Installation Instructions Manual

To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with the pq buttons. Alternatively, you can digit the channel number with the 0~9 buttons on
the remote control or press ok in viewing mode to display the channel list. The volume can be adjusted with the tu
buttons.

6.0 oPeRATion

6.1 changing channels

Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
„ „
Via the channel list using ok and the PG+/PG- buttons.
„ „
Via the pq buttons.
„ „
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote control. Channel
numbers can be up to four digits long. Entering a number with less than four digits is possible. Just wait a few seconds
and your receiver will switch to the selected channel or press ok immediately after selecting the channel number.
6.1.2 channel list
Press ok in viewing mode to display the Channel List. Use pq in the channel list to highlight your channel of choice
and press ok once to select the highlighted channel. Press ok again to leave the channel list mode. Inside the channel
list it is possible to use the PG+/PG- buttons as well in order to scroll page-wise through the list.
TiP: Use tu to toggle between the All Channel list and favourite list(s) or press fAv in viewing
mode for a list of the available favourite lists.
6.1.3 using the
pq
p switches to the next channel.
q switches to the previous channel.

6.2 info banner

While watching TV you can press the i button at any time to access current information about the channel and event*.
Press i twice for extended EPG details about the current channel. Press i three times for technical details about the
current channel.
*Event information is displayed when available. Availability depends on the broadcast.

6.3 selection of audio language

Some channels support a choice of audio formats and/or languages. To select another audio stream, press AuDio in
viewing mode. A list with available audio streams will now be displayed. Use pq to select a stream and confirm with
ok. The audio channel as stereo, mono, left and right can be selected with the tu buttons.

6.4 Teletext

Your receiver includes a fully featured Teletext. To access Teletext, press the TTX button in viewing mode and use the
0~9 buttons to input the number of the page you wish to see. The coloured buttons of the remote control allow you to
jump to selected pages directly, as indicated on the bottom of the Teletext screen. Use the pq buttons to select one
page up or down, use the tu buttons to select subpages. Press eXiT or TTX to get back to viewing mode.
8
buttons