Technical Specifications - Strong SRT 3000 Installation Instructions Manual

Problem
The receiver switches off
automatically.
Playback of video (or Timeshift) is
causing picture freeze/macro blocks
or similar distortion, especially on
HD content.

9.0 TechnicAL sPecificATions

Tuner
Tuner:
Input Impedance:
Minimum Input Level:
Receiving Channel Range:
Modulation:
Symbol rate:
video Decoder
Video decoder:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder
Audio support:
Audio mode:
*Dolby Digital Plus and the double-D symbol are registered trademarks of Dolby Laboratories.
Multimedia
Video playback:
Audio playback:
Picture view:
*STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on codec used, data bit rate and resolution (all
MPEG codec formats are supported).
system
Transponder:
Main Processor:
Demodulator:
Memory:
FLASH size:
connectors
Cable IN - IEC Female
Cable OUT - IEC Male (Loop through)
S/PDIF (coaxial)
HDMI
TV SCART
USB 2.0 port: DC 5 V, 800 mA (max.) supported
18
Possible cause
Auto Standby function enabled.
Read/write speed of your USB device
could be too low.
Maxlinear MXL608
75 Ohm
≤ 40 dBuv (64 QAM)
≤ 44 dBuv (256 QAM)
46 MHz ~ 862 MHz
64 QAM/256 QAM
3.6 M ~ 6.952 MS/s (64 QAM)
MPEG -2 MP@HL, AVC/H.264 HP@L4.1, MPEG-4 ASP supported
480i, 480p, 576i, 576p, 720p, 1080i, 1080p, By Source, By Native TV
PAL
4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
AAC/AC3+/PCM/Dolby® Digital Plus*
Stereo, Mono
MPEG-1 and MPEG-2 encoded (mpg), VOB, AVI, MKV, TS, M2T, M2TS,
MPEG-4 and MOV*
MP3 and OGG*
BMP and JPEG*
DVB-C (Digital Cable)
Ali M3812
Silicon SI2165
DDR II 64MB
4MB
What to do
Disable auto standby. See section
7.3.7 for details.
Make sure to use a USB storage
device with sufficient speed and
space. Pen drives ('USB sticks') may
not support sufficient speed.