Tools - Strong SRT 3000 Installation Instructions Manual

7.3.6 osD setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
Sets the duration time of on screen banners and messages remove. The range is 1~10 seconds
OSD Timeout:
or Always On.
OSD Transparency: To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press ok to clear all OSD settings and reset to default values.
7.3.7 Auto standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30Min/1 Hour/2 Hours or 3
Hours, the receiver will switch to standby if it doesn't receive any commands during this time. Set Auto Standby to Off to
deactivate the automatic standby function.

7.4 Tools

Press Menu in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press ok or u to enter.
Use pq to highlight the submenu of choice and press ok proceed.
Press eXiT to leave.
7.4.1 information
This submenu shows receiver specific information such as hardware version and software version. Please have the
Information screen on hand when you call our hotline. The person who answers your call might ask for the information
given in this screen.
7.4.2 Load factory settings
This option allows you to reset the receiver to factory settings, which clear all stored channels.
Warning:
By resetting your receiver to factory default, all your settings and stored channels will be
permanently deleted. Please use this option with care.
Use pq to select Load Factory Settings in the Tools menu and press ok. You are asked to input your PIN code.
Input the correct PIN code using the 0~9 (DefAuLT Pin: 1234). A confirmation window is displayed.
Select Yes to return to factory settings. Select No to cancel.
Press eXiT to leave.
7.4.3 s/W upgrade by oTA
This receiver is equipped with an Over The Air software upgrade function. An Over The Air update might not be
available in your region. Please visit our website www.strong.tv or contact your local service hotline for more
information about this option.
7.4.4 upgrade by usb
This feature allows you to upgrade receiver software via the USB port. When new software is available for your receiver,
it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory stick etc.) and connect
the device to the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press ok to proceed.
The upgrade menu will now be displayed.
Use pq to select Upgrade Mode and choose option Allcode.
Use pq to select Upgrade File and choose the file containing the latest and correct software.
When all settings have been made, move the highlight to Start and press ok to start the upgrade process.
14