Troubleshooting - Strong SRT 3000 Installation Instructions Manual

PS Record: Select between On or Off. When Off is selected, recordings will also include subtitles and
Teletext (when available). Record to PS mode On allows recordings without these extras and
will need less space on your USB device.
Press eXiT to leave this menu.
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
7.5.4 Remove usb device safely
Select Remove USB device safely from the tools menu and press ok. The receiver will display a message indicating that
you can safely remove your storage device from the receiver.
noTe:
After performing this function, the USB device is no longer accessible from your receiver. To
gain access to your storage device again, re-insert it or switch the receiver to standby and on
again.

8.0 TRoubLeshooTinG

There may be various reasons for abnormal operation of the receiver. Check the receiver according to the procedures
shown below. If the receiver does not work properly after checking it, please contact your dealer or the local Service
Hotline. Do NOT try to open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem
LED indicator not lit
No signal found
No picture or sound on TV or
amplifier
Scrambled channel
message
No response to remote control
Forgotten PIN code
Forgotten channel lock code
Signals are interrupted or blocking is
visible on screen
Possible cause
Mains lead unplugged
Cable input is disconnected
HDMI or SCART is not selected on
your TV or amplifier or the unit is
set to higher resolution as the TV
supports.
TV/amplifier is not switched on
Channel is scrambled
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Cable signals are too weak or have
reflections/interference.
What to do
Check mains plug
Check cable lead
Check with dealer
Switch to correct TV/amplifier input
Select lower resolution on receiver
Switch TV/amplifier on.
Check if S/PDIF connection is used.
Select alternative channel
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Default PIN is 1234
Contact local Service Hotline or
send email to our Support via
www.strong.tv
Press the i button on remote 3x to
call up signal bars and check your
cable connections and leads. Using
(many) splitters in the signal lead
might cause reflections/interference
in the digital signal and distort
reception. When in doubt, check with
your dealer.
17