Connection; Connecting To Cable Tv; Connecting To Tv With Hdmi Cable; Connecting To Tv With Scart Cable - Strong SRT 3000 Installation Instructions Manual

To use the remote control, point it towards the front of your receiver. The remote control supports a range of up to 5
meters distance to the receiver at an angle of up to approx. 30 degrees.
noTe:
Managing the receiver will be limited or not possible if there are obstacles between the
remote control sensor (at the front panel of the receiver) and the remote control. Direct
sunlight or very bright light can reduce or disturb the reception of the remote control signals.

3.0 connecTion

3.1 connecting to cable Tv

Connect your receiver to the wall connector provided by your cable operator, using a high quality coaxial cable (75
Ohms). Normally, wall connections could be either F-type or IEC male type. Use a cable with suitable connectors. This
receiver has an IEC female input.

3.2 connecting to Tv with hDMi cable

The TV set shall be connected with the receiver using a good quality HDMI cable. This connection gives the highest
possible quality.

3.3 connecting to Tv with scART cable

Your receiver is also equipped with a SCART connector; alternatively, the TV set can be connected to the receiver using
a good quality SCART cable.

3.4 connecting to a Digital Audio Amplifier with s/PDif

By connecting your receiver to a digital amplifier or home theatre system, you can enjoy the best possible sound
quality and multi-channel audio (depending on the broadcast). Connect your Digital Audio Amplifier or home theatre
system with a suitable cinch cable to the S/PDIF connector on the back of the receiver.

3.5 connecting to a Digital Audio Amplifier and Tv using hDMi

By connecting your receiver to the latest digital amplifiers or Home Cinema systems you will enjoy the best possible
sound quality and multi-channel audio (depending on the broadcast). Connect the HDMI output of the receiver to an
input of your amplifier, and then connect the HDMI output of the amplifier to your TV set. Select the correct input on
your amplifier to watch and listen to programmes.

3.6 connecting a usb storage device

Connecting a USB device to the unit allows you to playback movies, music and picture files. See chapter 7.5.1. Mediaplayer.
noTe:
It is recommended to use USB 2.0 storage devices or higher for playback of TV programmes
or HD movies.
noTe:
Timeshift/recording and playback only works properly when a fast USB storage device such
as a USB 2.0 HDD is connected to the receiver. Timeshift/recording and playback of HD
content requires a sufficient continuous read/write speed of the used USB storage device.*
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
6
Fig. 6
Fig. 6
Fig. 6
Fig. 6
Fig. 7
Fig. 8