Installing The Control Box Mount; Bolt, 1/4 X 3/4 Inch; Flange Nut, 1/4 Inch; Control Box Mount - Toro 41229 Operator's Manual

Spray system heavy duty workman vehicles

Hide thumbs Also See for 41229:

Operator's manual (40 pages)

Table of Contents

7. At the ROPS cover, rear of the seat assembly, route the

wiring harness up from under the seat and above the

frame. Make sure the spray system power connector is

out from underneath the vehicle (Fig. 8).

Figure 8

1. ROPS cover

2. Wiring harness

3. Left frame

8. Route the harness along the left frame and back to the

speed sensor with the existing wiring (Fig. 8).

9. Install the electrical connector to speed sensor.

10. Use wire ties to secure the harness to the existing

wiring and position it away from any moving parts and

heat sources.

11. Install the front hood and secure it with the screws

removed previously.

Installing the Control Box

Mount

On some vehicles the control mount plate is attached to

the dashboard at the same point the hand throttle assembly

is mounted. If the hand throttle kit is installed it must be

separated from the dashboard in order to install the control

mount plate. Refer to the Hand Throttle Kit Operator's

Manual for directions in removing and installing the hand

throttle assembly.

m–7219

4. Spray system power

connector

Installing the Adapter Plate

If you are installing the spray system on a Workman

vehicle with a serial number of 239999999 or lower, you

will need to use the adapter plate, bolts, and nuts included

in the loose parts.

1. Install the adapter plate to the Workman dashboard

using four bolts (1/4 x 3/4 inch) and four flange nuts

(1/4 inch) as shown in figure 9.

m–7152

Figure 9

1. Adapter plate

2. Bolt, 1/4 x 3/4 inch

3. Flange nut, 1/4 inch