Installing The Batteries - Epson PHOTOPC 800 User Manual

Installing the batteries

Before installing the batteries, be sure to read the
safety instructions in "When using the charger and
batteries" on page 4.
Make sure the camera is off, and follow these steps to
insert or replace the batteries.
1. Turn the camera upside down with the lens facing
you. Hold the PUSH button down and slide the
battery cover to the right to open the battery
cover.
1-6
Getting Started
PUSH button
2. Insert both batteries into the compartment,
positioning the + and - ends as shown below.
Then lower the battery cover.
3. Hold the battery cover down and slide it to the left
as shown in the illustration.
When the battery power is almost out, a low battery
icon appears on the display panel. When the
battery power runs out, this icon flashes and the
camera automatically turns off. Remove and recharge
your batteries, then install the batteries.