Epson PHOTOPC 800 User Manual page 20

1. Install the batteries into the compartments,
positioning the + and - ends as shown.
Caution:
c
Install and charge two or four batteries at a
time for your camera.
2. Connect the battery charger to the power cord as
shown below.
charger light
3. Plug the charger into an electrical outlet. The
charger light turns red indicating that the charger
is working.
Caution:
c
Be sure to insert all plugs and connectors
firmly and completely.
4. When the batteries are fully charged, the light
goes off. To charge your batteries again, unplug
the AC power cord, then plug it in again.
Note:
Replace the batteries with new Ni-MH batteries in the
following cases: the charger light stays on for more than
120 minutes (for 2 batteries), or 240 minutes (for 4
batteries); the charger light flashes for more than half
an hour.
5. After the light goes off, unplug the charger. To
avoid overcharging, do not leave the charger
plugged in for long periods of time after the light
goes off.
6. After the batteries cool, remove them from the
charger.
Warning:
w
Batteries are very hot (approximately 65°C)
during and just after charging. Wait one hour
for the batteries to cool before handling.
7. Before storing the charger, disconnect the AC
power cord and remove the batteries.
1
1-5
Getting Started