Installing Batteries - Epson PhotoPC 600 User Manual

NOTE
The charger lights flash to indicate changes in battery
temperature and voltage. If the charger lights continue to
flash for more than half an hour, the batteries may be
damaged or worn out, and should be replaced. Unplug the
charger if the batteries are not fully charged after two and a
half hours.
4
When both lights are off, unplug the charger. To avoid
overcharging, don't leave the charger plugged in for long
periods of time after the lights go off.
5
Wait one hour until the batteries cool before removing
them from the charger.
6
Before storing the charger, press down on the prongs to
lock the plug into place.
1-6 Getting Started
NOTE
Keep the charger terminals clean by wiping them with a dry cloth.
Make sure you charge all four batteries before you use them. If
you find that your batteries run out faster after you recharge them
a few times, make sure you discharge them completely before
recharging. If this doesn't help, replace the batteries.

Installing Batteries

Before you install the batteries, make sure the camera is
turned off (the lens cover is closed). Then follow these steps:
1
Turn the camera upside down with the LCD screen
facing you.