Installing The Batteries - Epson PhotoPC 3000Z User Manual

4. When the batteries are fully charged, the light
turns off. To charge your batteries again, unplug
the AC power cord, then plug it back in.
Note:
Replace the batteries with new Ni-MH batteries if the
charger light stays on for more than 240 minutes or if
the charger light flashes for more than half an hour.
5. After the light goes off, unplug the charger. To
avoid overcharging, unplug the charger as soon
as possible after the light goes off.
6. Allow the batteries cool, then remove them from
the charger.
w
Warning:
Batteries are very hot (approximately 65°C)
during and just after charging. Let the batteries
cool for one hour before handling.
7. Before storing the charger, disconnect the AC
power cord from the charger and remove the
batteries.

Installing the batteries

Before installing the batteries, be sure to read the
safety instructions outlined in "When using the
charger and batteries" on page 5.
Make sure that the camera is off, and follow the steps
below to install or replace the batteries.
1. Turn the camera upside down with the lens facing
you. Hold down the battery cover release button
and slide the battery cover as shown below.
battery cover
release button
1-7
Getting Started
1