Epson PHOTOPC 800 User Manual page 14

Be sure your AC power cord meets relevant safety
standards of the area where you plan to use it.
Do not use the batteries or charger near water or
handle them with wet hands.
Unplug the charger if the batteries are not fully
charged after four hours.
Power-supply cords should be protected from
abrasion, cuts, crimping and kinking. Be sure to
place your cords to avoid any damage. Do not
place objects on top of the power cord or allow the
power cord to be stepped on or run over. You
should take special care to try to keep the power
cord straight at the ends and the points where it
enters and leaves the transformer.
Unplug your equipment from the wall outlet and
refer servicing to qualified personnel under the
following conditions:
If the power cord or plug is damaged; if liquid has
entered your equipment; if your equipment has
been exposed to rain or water; if your equipment
has been dropped or damaged; if your equipment
is operating abnormally or exhibits a distinct
change in performance. Adjust only those
controls described in your product
documentation.
Do not attempt to service the charger yourself.
Refer all servicing to qualified service personnel.
Keep away from heat sources. Use the charger
within the temperature range of 5°C to 35°C (41°F
to 95°F).
Do not insert batteries into the charger backward
as they may explode, leak, overheat, or cause
personal injury.
Do not insert objects into any openings as they
may touch dangerous voltage points or short out
parts.
Never disassemble or modify the charger.
Use charger in a dry, indoor location.
Do not expose batteries or the charger to water or
high humidity.
Keep the charger out of reach of children.
Only use the batteries in EPSON Digital Cameras
as specified in this manual.
Never use EPSON Ni-MH batteries in
combination with any other type of batteries.
5
Introduction