Can-Am 2008 DS 450 Operator's Manual page 115

vmo2008-011-071_a
1. Lock nut
Hold adjustment screw using a flat
screwdriver, then loosen lock nut
counterclockwise.
vmo2008-011-085_a
1. Screwdriver
2. Special tool
By using the screwdriver, gently turn
clutch adjuster screw clockwise to lo-
cate the point of contact with release
bearing, then turn screw out (counter-
clockwise) 3/8 to 1/2 turn from contact
point
Hold adjustment screw using the flat
screwdriver, then tighten lock nut
clockwise using special tool.
vmo2008-011-085_b
1. Screwdriver
2. Special tool
To confirm proper adjustment, gently
push on adjustment screw using a fin-
ger, a small play should be felt, if not,
perform adjustment again.
CAUTION: A premature clutch disk
wear may occur if adjustment is too
tight.
vmo2008-011-071_b
1. Adjustment screw
Reinstall access plug.
CAUTION: Do not overtorque.
_____________________
113