Operations In The System Installer Mode - Omron Programmable Terminals NT31 NT31C Setup Manual

Operations in the System Installer Mode

6-5

Operations in the System Installer Mode

150
After initialization, the memory switch statuses are as follows.
Memory Switch
Start-up Wait Time
Key Press Sound
Buzzer Sound
Printer Controller
Print Method
Screen Saver Movement
Screen Saver Start up Time
Hist. Disp. Method
Resume Function
Comm. Auto-return
Time-out Interval
Retry Counts
Comm. A Method
Comm. B Select
Comm. B Method
* The communication conditions for a bar code reader are initialized as follows:
Data bits: 7 bits; stop bit: 1 bit; parity: none; flow control: RS/CS.
The following functions can be executed in the System Installer mode:
• Setting the display language (see below)
• Clearing/installing the system program (page 151)
• Disabling/enabling display of the System Menu (changing the system settings)
(page 153)
• Disabling/enabling writing to the screen data memory (changing the system
settings) (page 153)
• Clearing screen data (page 154)
For details on calling the System Installer mode, refer to Calling the System In-
staller Mode (page 138).
Status
00
ON
OFF
ESC/P
Tone (NT31C only)
Display erased
010
From New Data
OFF
OFF
01
005
Host Link (communications speed = 9600 bps)
RS-232C
None
Section 6-5
*